Walker SB36 - Manual (Page 36)

Removal and Storage Instructions
33
REMOVAL
1. Park the tractor on a level surface and lower the
snowblower.
2. Remove the hitch pins from the ends of the sup-
port arms.
3. Slide the PTO shaft out of the PTO coupler
while sliding the snowblower off the tractor sup-
port arms.
END OF SEASON STORAGE
1. Clean the snowblower thoroughly.
2. Repaint all parts where paint has worn.
NOTE: Rustproofing or painting every year
will prolong the life of the snowblower compo-
nents and moving parts.
3. When the snowblower is dry, lubricate all mov-
ing parts. Apply lubricant liberally to all surfac-
es to protect against rust.
4. Store the snowblower in a dry place.
WARNING
DO NOT attempt to remove the snow-
blower with the tractor engine running.
Disengage the PTO clutch, stop the en-
gine, and remove the ignition key. Wait
for all movement to stop before getting
off the seat.
To prevent accidental engine starting, dis-
connect the fuel solenoid wire [diesel
engines] or the spark plug wire(s) [gaso-
line engines].