Watlow Electric Micro-Based Autotuning Control SERIES 980/985 - Manual (Page 23)

Series
980/985
Keys
Figure 27 -
Series 980/985 Keys
UP/DOWN keys MODE Key
When pressed simultaneously for 3 sec- Steps the control through the
onds, the Setup Menu appears displaying Operating menu; also, in the
the LOC parameter. From the LOC pa- Auto mode, enters new data
rameter, press the UP/DOWN keys again selected less than 5 seconds
and the Calibration Menu appears. previously .
Increases the value
of the displayed
parameter. A light
touch increases the
value by one.
Holding the key
down increases the
display value at a
rapid rate. New
data is self entering
in 5 seconds.
DOWN Key
Decreases the value of the
displayed parameter. A light
touch decreases the value by
one. Holding the key down
decreases the displayed value
at a rapid rate. New data is
self entering in 5 seconds.
Where To Go From -Here
AUTO/MAN Key
Pressed once, it clears any
latched alarms. If the key is
pressed again within 5
seconds, the control toggles
between the Auto and Manual
mode. While in the Manual
mode, percent power is
always displayed in the lower
display.
Auto/Manual LED
Lit when the control is in Manual opera-
tion. Press the key twice to enter Auto
operation. A blinking Auto/Manual LED
indicates that pressing the Auto/Manual
key toggles between Auto and Manual.
After 5 seconds without pressing the
Auto/Manual key, the LED stops blinking,
and returns to its previous state.
Now that you know how to read the keys and displays, continue to Chapter 4 to
begin entering data and setting up your Series 980/985.
Keys and Displays, Chapter 3
WATLOW Series 980/985 User’s Manual 23