Wolfcraft 6155 - Manual (Page 21)

21
Always remove router bits
and unplug router before
mounting to router table.
The table will accept routers with bases
up to 7" in diameter. There are two
methods for attaching routers to router
table.
MOUNTING THE ROUTER
WARNING
If your router is not one of those listed
in the chart, place the router base plate
on top of the router table and rotate the
base plate until the holes are aligned.
When the two hole patterns line up,
your mounting pattern has been
identified. See Figure 18.
Specific Model
Numbers
Most routers
mount with plate
#R160K, #R160V,
#R165, #R180
#27500, #27510,
#27511
#R174, #RE175
#690, #6931
#1823, #1835,
#1845-02,
#17504, #17505,
#17506
All
n/a
n/a
n/a
Hole
Pattern
A
B
C
D
E
F*
G
H
J
Router Brand/
Hole Use
Square Adaptor Plate
Mounting Holes
Ryobi
Craftsman
Ryobi
Porter Cable
Skil
Craftsman
Dremel™ Rotary
Hobby Tools
Threaded Hole for
Pilot Pin
Pilot Pin Storage Hole
Dovetail/Box Joint
Fixture Mounting Slots
Dremel™ is a registered trademark of S-B Power Tool
Company.
*Mounts with Dremel™ #330 Router Attachment Kit (not
included, see below).
At least three holes should be aligned
for proper support of the router. If fewer
than three holes line up, follow
instructions on how to mount your router
with the square adaptor base plate (Z)
on the next page.
Figure 18
F F
G
E
H
E
J
E
A
A
A
A B
B/C
D D
D
B B/C
J