Wrangler JEEP P5063 - Manual (Page 11)

P5063pr-0923
• Insert the steering column assembly into the large hole in the
dashboard. Make sure the bend in the steering column is UP.
Steering
Column
Large Hole in
Dashboard
Bend Up
8
11
ASSEMBLY F
BOTTOM VIEW
• Carefully, turn the vehicle over, keeping the steering wheel and
steering column in place.
• Fit the end of the steering column through the hole in the
steering linkage.
• Fit a steering column cap on the end of the steering column
and hold it in place.
Steering Column Cap
End of Steering Column
9
Steering Linkage
7
• While holding the steering wheel, grasp the steering column
and push it up as far as it will go.
• Insert the 5 /
32
" x 1½" pin through the hole in the end of the
steering column.
• Now, pull the steering column down to fit the pin into the
grooved area in the center of the steering wheel.
• Fit the steering cap into the center of the steering wheel. Be
sure to align the notch in the steering wheel cap with the tab
in the center of the steering wheel.
• Insert two #8 x ¾" screws into the steering wheel cap and
tighten.
Steering Wheel Cap
Steering Wheel
6
5 /
32
" x 1½" Pin
End of Steering Column
PUSH
PULL
P5063a-0920