WindChaser Products PACR12 - Manual (Page 8)

Horizontal Vertical
If you need to extend your exhaust hose, it may be
extended 5 feet only using 4 in PVC pipe (available at
your local hardware store) for a maximum exhaust
length of 10 feet. DO NOT USE DRYER TYPE
EXHAUST HOSE TO LENGTHEN EXHAUST.
7
EXHUAST KIT INSTALLATION
WINDOW INSTALLATION
Panel (A)
Exhaust Window panel
Kit adjusts from 33 inches to
56 inches to fit various
window sizes.
2
1 3
4
NOTE: FOR DEHUMIDIFYING MODE, THE EXHAUST HOSE DOES NOT NEED TO BE INSTALLED.
1) Remove the adapter cover from the wall/window panel adapter and attach the wall/window panel adapter to Panel (A) of
the window kit.
2) Attach Panel (A) to Panel (B), place the combined panel inside your window frame and adjust the size of the combined
panels to fit the window opening by sliding Panel (B) upwards or sideways.
3) Use the clips attached to Panel (A) to lock the panels into place. The clips are to be placed on the “L” shaped edges of
Panel (A) at the point where Panel (A) meets Panel (B).
4) Close the window up against the panels to secure them in the window frame.
5) Twist the grey connector onto the exhaust hose and then pass Drain (A) through the exhaust hose before connecting the
grey connector to the back of the unit (you must do this whether or not you use Drain (A)).
6) Twist the white connector onto the opposite end of the exhaust hose, take Drain (A) and feed it through the wall/window
adapter, and snap-lock the white connector into the wall/window panel adapter.
NOTE: For the most effective cooling, remove the adapter’s cover
when the unit is running.
NOTE: Drain (A) will not work if it’s raised more than 5.9 feet
above the ground.
1. Drain Hose (A)
2. Grey Hose Connector
3. Exhaust Hose 4. White Hose Connector
5. Wall/Window Panel Adapter
6. Adapter Cover
7. Adjustable Window Panel
Window Panel Kit
5
Panel (B)
Clips
6
6