Woods Equipment PRD6000 - Manual (Page 11)

Operation 11
MAN0475 (9/21/2005)
1. Attach the mower hitch pins to the lower tractor lift
arms and secure.
2. Attach tractor top link (1), Figure 2, to mower top
link bracket attachment point A. Connect the
driveline to the tractor PTO shaft.
Figure 2. Attachment Points
Figure 3. Attaching Mower to Tractor
3. Attach tether chain to tractor drawbar (Figure 3).
4. Adjust the tractor lower 3-point arm anti-sway
devices to prevent mower from swinging side to
side during transport.
CUTTING HEIGHT ADJUSTMENT
„ Keep all persons away from operator control
area while performing adjustments, service, or
maintenance.
IMPORTANT
■ Avoid low cutting heights. Striking the ground
with blades produces one of the most damaging
shock loads a mower can encounter. Allowing
blades to contact ground repeatedly will cause
damage to mower and drive.
1. Level mower from side to side. Check by
measuring from mower frame to the ground at
each deck rail.
2. Verify that the same amount of spacers are under
all caster arms.
3. Loosen cap screws that attach caster arm
assembly to deck.
4. Set mower on the ground.
5. Retighten cap screws. This equalizes the
clearance in the bolt holes.
6. Adjust front of mower level with or slightly lower
than the rear to obtain best mowing results.
7. Control cutting height by adjusting front and rear
caster wheels.
8. To raise rear of mower, move caster adjustment
spacers under rear caster arms, .
9. To raise front of mower, move spacers under front
caster wheel arms.
Figure 4. Cutting Height Adjustment
Remember, measurement at location A (Figure 4)
should not be less than location B and should not be
over 1/2" greater than location B.
1. Tractor top link
A. Mower top link
attachment point
B. Mower hitch pin
D. Lower hitch plate
attachment point
E. Mower hitch plate
CM906
Tether Chain
WARNING