Woods Equipment PRD6000 - Manual (Page 31)

Assembly 31
MAN0475 (9/21/2005)
Fill Gearbox
IMPORTANT
■ Gearbox is not filled at the factory. Prior to
delivery, make sure each gearbox is filled half-full
with 80W or 90W API GL-4 or GL-5 gear lube.
1. Make sure vent plug hole is clear. Fill gearbox half-
full with high quality gear oil that has a viscosity
index of 80W or 90W and an API service rating of
GL-4 or GL-5.
2. Fill gearbox until oil runs out the side plug on
gearbox.
3. Pour in one pint of gear lube, wait five minutes and
add additional gear lube until it just comes out of
side hole.
4. Allow an additional five minutes for the lube to flow
through bearings, then check to make sure oil level
is at bottom of side hole. Replace side plug. Install
vent plug.
Install Chain Shielding (Optional)
„ Full chain shielding, designed to reduce the
possibility of thrown objects, must be installed
when operating in populated areas or other areas
where thrown objects could injure people or dam-
age property. If this machine is not equipped with
full chain shielding, operation must be stopped
when anyone comes within several hundred feet.
3. Shield, chain plate
14. Bolt, carriage 3/8 NC x 1
15. Nut, flanged lock 3/8 NC
Figure 33. Chain Shield Installed
1. Install chain shielding plate (3) to rear mower frame
as shown.
2. Secure with carriage bolts (14) and flanged lock
nuts (15).
Insert carriage bolts from bottom upward as
shown.
Install Front Roller (Optional)
1. Insert four carriage bolts (5) through the front
mower frame from inside out.
2. Place roller bracket (8) over bolts; then install
flange whiz nuts (6) on bolts and tighten.
3. Place front roller (9), two bearings (10), spacer (7)
and two SAE flat washers (4) between roller
bracket as shown in Figure 34.
4. Insert cap screw (3) through bracket and roller.
5. Secure with flanged lock nut (2). Do not
overtighten, roller must spin freely.
Figure 34. Front Roller Installation
Install Quick Hitch Kit (Optional)
NOTE: This kit allows mower to fit only Category 1
standard quick hitch.
1. Make sure that you are using one of the front two
attachment points (D) in the lower hitch plates. See
Figure 6, page 12, for adjustment.
2. Remove clevis pins from lower hitch arms. The
pins will not be used for the Quick Hitch.
DANGER
15
3
14
CM768
2. 1/2 NC Flanged lock nut
3. 1/2 NC Flanged lock nut
4. 1/2 SAE Flat washer
5. 3/8 NC x 1 Carriage bolt
6. 3/8 NC Flanged whiz nut
7. Spacer, .75 x 6.62
8. Bracket, front roller
9. Roller, 4 x 7.37
10. Bearing