Wayne-Dalton Z-Wave WDUSB-10 - Manual (Page 13)

Removing Modules from Network
13
Use the following procedure to
remove Z-Wave
®
modules from
your Z-Wave
®
network.
1. From the Design tab, press the
ReMoVe DeVICe button. A message
window will ask you to press the
button on the device to remove.
2. Press-and-release the PRoGRAM
button on the Z-Wave
®
module. If
successful, a message window will
appear stating that the device has
been successfully removed. Repeat
this procedure if a message window
states that the module failed to be
removed.
NoTe: Please see the User
Manual or Instruction Manual for
the specific Z-Wave
®
module
being programmed to locate the
PRoGRAM button and for specific
programming information.
NoTe: The process of removing
modules from a network is often
referred to as eXCLUSIoN.
NoTe: You can also reset modules
in other networks using the ReMoVe
DeVICe button. If the target module
is part of another network, it will
be reset instead of removed from
your network. Please note that
some modules do not support being
reset in this manner and so this
procedure will fail; in such cases,
refer to the module’s documentation
for manual reset instructions.
Common Operations
O N/O
FF
PR O G./
DIM
Press-and-Release
PRoGRAM button on
module

Press ReMoVe DeVICe to remove a Z-Wave
®
module
Device removed successfully message window.
