Wayne-Dalton Z-Wave WDUSB-10 - Manual (Page 25)

Removing Controllers
from the network
25
Use the following procedure to
remove secondary controllers
from a network where
ThinkEssentials
®
is the primary
controller.
It is best practice to remove a
secondary controller from your
network prior to re-setting it when
it is no longer needed or if the
secondary controller is to be reset
for any reason. This procedure is
similar to the procedure “Adding
a Controller to the Network” (see
page 24), but “Remove Device”
from Thinkessentials
®.
1. From the Design tab, press
the ReMoVe DeVICe button. A
message window will ask you to
press the button on the device to
remove.
2. Place the secondary controller
into ReCeIVe RePLICATIoN or CoPY
FRoM mode. (Please see the User
Manual or Instruction Manual for
the specific Z-Wave
®
controller
being programmed for detailed
programming information.)
If the operation is successful,
a message window will appear
stating that the device has been
successfully added. Repeat this
procedure if a message window
states that the module failed to be
included.
NoTe: For your security, the USB
Z-Wave
®
Adapter must be within
3 feet of the controller to be
removed.
Network Operations
oN oFF
1
2
3
4
5
6
DeLeTe INCLUDe
example of
Secondary
Controller


Device removed successfully message window.

Press ReMoVe DeVICe to remove a secondary controller.
Initiate Secondary Controller to ReCeIVe RePLICATIoN.