weber 98642 - Manual (Page 22)

22
Slot in frame
(view from below)
Insert one end of the hinge rod into the hole in the frame.
Figure 31 (a).
Insert the other end into the hole in the swing table end
bracket. Figure 31 (b). Hold the end bracket at an angle so
the lower tab is inside the frame tube. Push the bracket into
the frame. Check to see that the lower tab of the bracket is
hooked in the slot in the frame. Figure 31 (c).
To fully seat the bracket, you may have to tap it lightly with
a hammer.
ƽ
WARNING: If swing table end bracket is in any way
cracked or damaged, do not use swing table. Call our
Customer Service Center to order a new part.
ƽ WARNING: The load limit for the swing table is
30 pounds.
Figure 31
(c)
View from rear
of barbecue
Hinge rod
(b)
(a)
Position slide bar assembly on the outside of the caster
frame. Put a nylon washer on each 1 3/4 inch screw, insert
screws through frame and slide bar assembly and add
nylon washers and hex nuts. Tighten nuts using a
screwdriver and pliers. Figure 32.
Figure 32
View from front
of barbecue
Notch to the front
Slide bar
To lower table: Pull support rod up to disengage slide lock,
and lower table. To raise table, lift table up and engage slide
in locked position. Figure 33.
View from rear
of barbecue
Support rod
Locked position Unlocked position
Figure 33
Slide