Contents of carton, Positioning the upper handle, Attaching the control cable – White Outdoor SB 45 User Manual
Page 5: Installing the extended chute directional control
5
SECTION 2: ASSEMBLING YOUR SNOW THROWER
Contents of Carton
Before beginning installation, remove all parts from the
carton and compare them to Figure 1. Carton contents
are listed below with part numbers in parentheses.
•
Two
Ignition Keys (725-0201 & 725-1341B)
•
Extended Chute Directional Control Assembly
(747-0737, 720-0201A & 726-0100)
•
One Cotter Pin (714-0507)
Figure 1
NOTE: All references to left or right side of the snow
thrower is from the operating position only.
WARNING:
Disconnect the spark plug wire
and ground it against the engine to prevent
unintended starting.
Positioning the Upper Handle
•
Remove packing material, if present, and loosen
the wing knobs found on each side of the handle.
•
Making sure not to pinch or crimp the cable in the
process, pivot the upper handle into the operating
position as illustrated in Figure 2 until it clicks into
place.
•
Tighten the wing knobs to secure the handle in
place.
Attaching the Control Cable
The control cable may already be attached to the
control handle. If it’s not, complete the following steps
to attach it to the snow thrower housing.
•
Route the control cable over the crossbar where
the lower handle meets the upper handle.
•
Pivot the control handle forward.
Figure 2
Figure 3
•
Insert the end of the control cable into the bottom
hole in the control handle, from the outside to the
inside, as shown in Figure 3.
•
Push the plastic fitting into the control housing until
it clicks in place
NOTE: The upper hole in the control handle provides
for adjustment in belt and cable tension. Refer to page
8 of this manual for instructions.
Installing the Extended Chute
Directional Control
•
Insert the chute directional control through the
eyebolt and into the coupler found in the top right
area of the snow thrower’s shroud. See Figure 4.
Ignition Key w/ Plastic Cover
Standard Ignition Key
Cotter Pin
Extended Chute
Directional Control Assembly
Wing Knob
Wing Knob
Upper Handle
Control Handle
Control Housing
Plastic Fitting
End of Cable
In Bottom Hole
Upper Hole