White Outdoor SB 45 - Manual (Page 6)

6
• Rotate the chute directional control to align the hole
in the coupler with the hole in the chute directional
control, and insert the cotter pin through both holes.
Bend the ends of cotter pin in opposite directions to
secure it in place. See Figure 4.
Figure 4
Assembling the Discharge Chute
For shipping reasons, the snow thrower has been
packaged with the upper chute pivoted all the way
down. To pivot it upward, proceed as follows:
Figure 5
• Turn the chute directional control until the chute
opening is facing straight ahead.
• Remove the wing knob, flat washer and carriage
bolt from the upper chute. See Figure 5.
• Pivot the upper chute upward over the lip on the
lower chute so that there is NO gap between the
upper chute and the lower chute. See Figure 5.
• Resecure with the hardware just removed.
SECTION 3: KNOW YOUR SNOW THROWER
Cotter Pin
Chute Directional Control
Coupler
Eye Bolt
Upper Chute Wing
Knob
Flat
Washer
Carriage Bolt
Front
Lower Chute Lip
Ignition Key
Choke Lever Starter
Spark
Plug
Cover
Primer
Upper Handle
Discharge Chute
Fuel Cap
Chute Directional Control
Handle
Control Handle
Auger
Shave Plate