Whynter ECO-FRIENDLY ARC-10WB - Manual (Page 12)

12 | P a g e
Window kit Installation in a sliding door/ window
1. Open window or sliding door for approximately 5”
2. Cut the foam seal (adhesive type) to the
proper l ength and attach it to the bottom
of the door / window. Fig.14
.
3. Adjust the length of the window bars to the same
length and width of the opening of the window.
Cut the window piece if necessary to fit the length
of your window. Fig. 15.
4. Close the door/ window on the window slide bars.
For long term installation, you may screw the
window kit into your window frame. Fig. 16.
5. Cut the foam seal to the length and seal
the open gap between the top window
sash and outer window sash. Show in
Fig.17.