Operating condition – Whynter ECO-FRIENDLY ARC-10WB User Manual

Page 5

Advertising
background image

5 |

P a g e

Do not allow children to climb, stand or hang on the appliance. The air conditioner could tip

over and get damaged and/or seriously injure somebody.

Keep fingers out of the air intakes and air outlets.

The appliance is an electrical appliance. To avoid injury from electrical shock do not operate

it with wet hands, while standing on a wet surface or while standing in water. Do not use it in
outdoors or in wet conditions.

When positioning or moving the appliance, ensure it is not turned upside down or greater

than 45° or more off level.

This appliance is designed for household, non-commercial use only. Any other use will void

the warranty.

Do not plug into the power outlet before set up is completed.

Do not operate this unit without the air filter(s).

Do not use harsh chemicals to clean the filter(s). Dry thoroughly before inserting the filter(s)

into the unit.

Do not add extra length to the exhaust hose by more than a total length of 9‟. This will
reduce the cooling efficiency of the portable air conditioner.

At the end of each season, all water must be drained from the unit and filter(s) must be

cleaned before storage.

THE MANUFACTURER DISCLAIMS ANY RESPONSIBILITY IF THE ABOVE INSTRUCTIONS

ARE NOT FOLLOWED.


OPERATING CONDITION

MODE

ROOM TEMPERATURE

COOL

Higher than 62°F / 17°C

DRY

Higher than 54°F / 13°C





Your portable air conditioner is supplied with a Leakage-Current
Detection and Interruption (LCDI) plug. This plug reduces the risk of
fire due to arcing faults in the power supply cord. Please follow the
instructions below to ensure that LCDI plug works properly.

1. Plug the power cord to a grounded wall outlet. Do not plug to

a power strip or extension cord.

2. Press the TEST button on the plug. This should trip the plug

and cut the power to the air conditioner. If the plug does not
trip and the unit comes on, please contact technical support.

3. Press the RESET button to start the air conditioner.

4. Do NOT use the TEST and RESET buttons to turn the air

conditioner on and off.

Advertising