Wells VENTLESS HOOD WVSW - Manual (Page 8)

ELECTRICAL INSTALLATION
Refer to the nameplate. Verify the electrical power source. Voltage
and phase must match the nameplate specifications. Plugging the
hood into the wrong voltage can severely damage the unit .
Your hood is equipped with a grounded electrical cord. This cord
must be plugged into a properly grounded NEMA 5-15R (120V) or
NEMA 6-15R (208/240V) single phase receptacle.
Fig. 3 Electrical Plug and Receptacle Configuration WARNING!
Electric
Shock hazard
All servicing requiring
access to non-insulated
electrical components
must be performed by a
factory authorized
technician.
DO NOT open any access
panel which requires the
use of tools. Failure to
follow this warning can
result in severe electrical
shock.
CAUTION!
Electrical Shock
Hazard
The ground prong of the
power cord is part of a
system designed to protect
you against electric shock in
the event of internal damage.
DO NOT cut the ground
prong (large round prong) or
twist a blade to make the plug
fit an existing receptacle.
IMPORTANT:
Contact a licensed electrician
to install and connect
electrical power to the
appliance.
IMPORTANT:
Damage due to being
connected to the wrong
voltage or phase is NOT
covered by warranty.
INSTALLATION (continued)
6