Whynter T-1A - Manual (Page 6)

T-1 Version 08/05 6
Appliance Operation
Plug the appliance mains electricity lead in to a suitable supply and switch on the
ON/OFF Switch situated in the lower right hand side panel. The ON/OFF Switch
is illuminated and will light up. The appliance should be positioned for easy
access to the ON/OFF switch and mains plug to facilitate rapid switch off and
appliance isolation when required.
For the T-1A model Direct Water Supply mode. Please i) connect a hose to the
water mains and to the unit, ii) turn the unit on. and iii) turn on your water mains.
The appliance may beep several times whilst the internal components reset
themselves. If this does happen the beeping should last no longer than 20
seconds. If beeping continues for a longer period withdraw both the Water Tank
and the Ice Cube Drawer slightly and re-insert them ensuring they are fully home
within their recesses. When the Water Tank is withdrawn the WATERTANK
indicator should change from green to red or red/orange, and when re-inserted
the indicator should go green. If the WATERTANK indicator stays red or
red/orange this could mean that the internal water level detector is not operating
correctly. Remove the Water Tank and check that the black float in the
transparent level indicator on the rear right hand side of the tank is free, i.e. that
the float is not stuck at the bottom of the detector. If the float is stuck gently tap
the indicator to free the float. Replace the Water Tank.
For the T-1A model, in Direct Water Supply mode, users do not need to remove
the water tank. The unit will automatically draw the water supply into the water
tank. The unit will stop drawing water once the water tank is filled. At this point
you may choose to shut off the water mains or leave it on. Once the water tank
has been filled, you will be able to select your ice size and start the ice making
cycle. If you have chosen to leave the water mains on, the unit will start to draw
water into the tank again once it is empty. A low water level indicator float will be
apparent if the water supply has been interrupted. Then the machine may also
be operated in manual mode.
The ice cube size S (small) of the SELECT button should be illuminated red as
this is the default setting. If it isn’t press the S button to illuminate it.
Press and hold down for two seconds the START button on the Function Display.
The appliance will start with the water pump, cooling fan and compressor starting
to operate. Looking through the right hand side of the window in the cover water
will be seen entering the water tray.
After approximately 12 minutes ice cubes will be deposited in the Ice Cube
Drawer and the appliance will beep four times .Do not attempt to remove ice