Wisdom Audio Wisdom & Sage Series SC-1 - Manual (Page 11)

11
ቢ ባ ቤ
Front Panel
1 Power Switch, Standby Indicator and Input Clip Indicator
The SC-1 features a sculpted front panel that conceals two switches under
the flexible ends of the middle section. On the left side, gently pressing
the end of the center section will engage a microswitch under the face of
the SC-1, which will in turn toggle the unit between operate and standby
modes. The international symbol for power is inscribed in this location
to designate its purpose.
The amber LED indicator on the left side of the center section is lit when
the SC-1 is in standby to indicate that it is receiving power; it is off when
the SC-1 is either fully on or when there is no power being supplied to the
unit. (When the SC-1 is fully on, one of the setup memory LEDs will be lit
to indicate both power and which setup memory is being used. If all the
LEDS are off, no power is being supplied to the unit.)
The SC-1 requires several seconds to “boot up” when coming out of stand-
by. The amber LED flashes during this startup process, turning off when it
is complete. One of the Setup Memory LEDs will turn on at this point to
indicate which memory is active).
Finally, if the SC-1 detects input clipping on any of its channels, the
Standby LED will flash rapidly for three seconds. If the clipping continues
(at least once per three-second interval), it will continue flashing. In the
unlikely event that you see this indication, you should turn the system
volume down to reduce distortion and potential damage to your speakers.
2 Setup Memory LED Indicators
The Wisdom System Controller incorporates the latest version of
Audyssey MultEQ ® XT room correction to enable it to address room-
specific problems that would otherwise compromise performance. Under