Wegener Communications DTV742 - Manual (Page 3)

800057-02 Rev. A Page 3 of 11 May 24, 2003
Main-level Screens Second-level Screens
2 nd -level RF Input
Where X is the RF port number.
Press ENT to go to the third-level Input Setup Screens below and
use the
5 or 6 keys to select <ON> or <OFF>, adding or
removing this program to/from the output stream. Press ENT
again to confirm.
Press the
4 key to go to the next RF Input screen (1 through 4).
Press the ESC key to return to the Input Setup screen.
3 rd -level Tuner Enable
Press the ENT key to toggle between ON and OFF, enabling or
disabling the tuner.
Press the
4 key to go to the Channel Number Selection screen.
Press the ESC key to return to the second-level RF Input screen.
3 rd -level Channel Number Selection
Where XX is the current channel number.
Press ENT to enter the edit mode and use the
5 or 6 keys to
change the channel number. Press ENT again to confirm your
selection or ESC to cancel changes.
Press the
4 key to go to the RF Standard screen.
Press the 3 key to go to the Tuner Enable screen.
Press the ESC key to return to the second-level RF Input screen.
Input Setup
Press the ENT key to bring up the second-level Program
Input screen.
Press the
4 key to go to Program Status.
Press the 3 key to go to Clear Errored Seconds (if counter is
non-zero) or Alarms/Warnings.
Press the ESC key to go to the Home Screen.
3 rd -level RF Standard
Press ENT and use the 5 or 6 keys to toggle the RF Standard
between Broadcast and Cable. Press ENT again to confirm your
selection or ESC to cancel changes.
Press the
3 key to go to the Channel Selection screen.
Press the ESC key to return to the second-level RF Input screen.
I n p u t S e t u p . . .
R F I n p u t X
T u n e r E n a b l e :
O N
C h a n n e l N u m b e r : X X
R F S t a n d a r d :
B r o a d c a s t