Wegener Communications DTV742 - Manual (Page 6)

800057-02 Rev. A Page 6 of 11 May 24, 2003
Using the Web Browser –
Using the web browser of your choice, set the Address to http://nnn.nnn.nnn.nnn where nnn.nnn.nnn.nnn is the IP address of
the unit to be controlled. Each unit on the network must have a unique address. You should see the pages below when connected
to the unit. (Be sure that your screen resolution is set to at least 1024x768 so that all items are visible. Lower resolutions will
prevent you from viewing all the available tabs.) You may select which page to view by clicking on the Control and Status, Stream
Information, Unit Configuration, Config In, Config Out (1, 2, 3, or 4), or Q&A/Help tabs.
The Control and Status tab (shown below) allows you to select the channel number for the RF input. The status section provides
signal status.