Wells F-88 - Manual (Page 7)

5
INSTALLATION (continued)
WARNING: ELECTRIC SHOCK HAZARD
All servicing requiring access to non-insulated electrical components must be performed by a
factory authorized technician.
DO NOT open any access panel which requires the use of tools. Failure to follow this warning
can result in severe electrical shock.
CAUTION:
RISK OF
DAMAGE
DO NOT connect or energize
this appliance until all
installation instructions are
read and followed. Damage
to the appliance will result if
these instructions are not
followed.
CAUTION:
ELECTRICAL
SHOCK HAZARD
The ground lug of the fryer
must be connected to a
suitable building electric
ground.
IMPORTANT:
Damage due to being
connected to the wrong
voltage or phase is NOT
covered by warranty.
NOTE:
Fryers are shipped from the
factory with the basket lift in
the UP position.
FRYER ELECTRICAL INSTALLATION
Countertop autolift fryers must be connected directly to a suitable
electric circuit. Conduit and strain relief must be provided by the
electrician. Refer to nameplate for voltage and amperage requirements.
Single phase fryers require a 208VAC or 240VAC 1ø circuit with gound.
Three phase fryers require a 208VAC or 240VAC 3ø ciruit with ground.
Raise the element head, remove the frypot and the cover at the rear of
the fryer to gain access to the terminal block. The electrical inlet is
provided by a knock-out in the rear panel.
If an equipment shutdown interface is required by local fire code, the
flame sensor terminal block may be accessed by removing the back
panel. Replace the jumper of the terminal block with wiring to a normally
closed contact of the building fire management system.
DO NOT connect power to the flame sensor terminal block. Wiring and
contacts must be capable of handling 30 amps.
F-68 and F-88 FRYERS ARE SHIPPED FROM THE FACTORY
WIRED FOR 3ø. Conversion to single phase is the responsibility
of the electrician.
M
302 p/n 30
7589
OpM
Counterto
p A
u
toli
ft Frye
rs