Scarlett IS-502 User Manual
Page 7
5
GB
INSTRUCTION MANUAL
3. INSTRUCTION FOR USE
3.1. FILLING
• In order to fill the kettle with water take the kettle off its
base, open the lid by pressing the lid opening button,
pour in the water observing the water level scale.
• In order to avoid overheating the kettle do not pour in
more than 0.5 liters of water (below “MIN” mark). Do
not pour in more than 1.7 liters of water (above “MAX”
mark), otherwise the water may overflow through the
nozzle when it starts boiling.
• Close the lid tightly.
3.2.TURN ON
• Put the filled kettle onto the base; it is possible to put
the kettle the way it is convenient for you since the base
allows for 360° rotation of the kettle.
• Plug the power cord into the socket.
• Button lights on the base will turn on. The lights will stay
on for 5 minutes, and then the lights will turn off.
• The lights show that the device is ready to operate.
3.3.BOIL THE WATER
• To boil the water press the boil button: the button light
will start blinking and the kettle will start heating the
water. Once the heating cycle is over, the light indicator
will stop blinking and it will remain on for 5 minutes.
3.4.HEAT THE WATER TO CERTAIN TEMPERATURE
• Press one of the buttons for temperature heating and
select the needed temperature (60
0
C, 70
0
C, 80
0
C or
90
0
C); the button light will start blinking and the kettle
will start heating the water.
• The temperature recommended for tea brewing:
• 60
0
C- white tea
• 70
0
C- red tea
• 80
0
C - green tea
• 90
0
C - black tea
• Once the water heats up to the specified temperature
the button light will stop blinking and it will remain on for
5 minutes.
3.5.HEAT THE WATER
• This regime is used to maintain the water of needed
temperature for 30 minutes.
• Press one of the buttons for temperature heating and
select the needed temperature (60
0
C, 70
0
C, 80
0
C or
90
0
C) (the button light will start blinking).
• Press the heating button (the heating button light will
turn on), and the kettle will start heating he water.
3.6.TURN OFF
• You may turn the kettle off by taking it off the base or by
pressing the button of the selected regime again.
• ATTENTION: Your kettle is equipped with overheating
protection system. If there is too little or no water in the
kettle, it will turn off automatically. If this happens you
have to wait for at least 10 minutes until the kettle cools
off. Then you may fill the kettle with water again.
3.7.SUBSEQUENT TURN-ON
• Wait 15-30 seconds after the kettle turns off; then you
may turn it on again to boil the water.
4. CARE AND CLEANING
• Remove the plug from the socket and let the appliance
cool down completely.
• Open the lid and pour out the water.
• Clean the outside of the kettle and the base unit with a
soft damp cloth, then wipe with a dry cloth. Do not use
any abrasive materials.