Weslo WLEVEX12920 - Manual (Page 5)

5
3
9
43
19
45
1
13
Hole
Zip Tie
Adjustment
Holes
36
3. Whilst another person holds the Upright (13) in the
position shown, connect the Upper Wire (36) to the
Reed Switch Wire (43). Cut and remove the zip tie
holding the Reed Switch Wire to the Frame (1). Next,
connect the Resistance Cable (19) to the Lower Cable
(45) in the following way:
• See drawing A. Press the small cylinder on the end
of the Resistance Cable (19) into the hole in the con-
nector on the Lower Cable (45). Pull the Resistance
Cable up and slide it into the slot in the top of the
connector.
• See drawing B. Turn the Resistance Cable (19) until
it is aligned with the slot in the connector, and press
the Resistance Cable down into the connector. The
Resistance Cable will lock into place.
Carefully pull the excess Upper Wire (36) out of the
top of the Upright (13), push the excess Cable (19, 45)
down into the Frame (1), and insert the Upright into the
Frame. Be careful to avoid pinching the Wires and
Cables. Next, align one of the adjustment holes in the
Upright with the indicated hole in the Frame. Insert the
Adjustment Knob (9) into the Frame and the Upright,
and turn the Knob clockwise until it is tight. Make sure
that the Knob is inserted through one of the
adjustment holes in the Upright.
4
4. The Console (16) requires three 1.5V AA batteries;
alkaline batteries are recommended. Insert three bat-
teries into the battery compartment. Make sure that
the batteries are oriented as shown by the mark-
ings inside the battery compartment.
A B
45
16
19
19
Batteries
Cylinder
Connector
Connector
Slot
Hole
Be careful to
avoid pinching
the wires and
cables whilst
inserting the
Upright.