Westinghouse MT80 THIN - Manual (Page 2)

2 of 8 ISSUED: 03-02-05 SHEET #: 201-9323-1
Visit the Westinghouse Web Site at www.westinghousedigital.com For customer service call 1-866-287-5555 .
Note: Read entire instruction sheet before you start installation and assembly.
Tools Needed for Assembly
• stud finder ("edge to edge" stud finder is recommended)
• phillips screwdriver
• drill with 1/4" and 5/32" drill bits
• Do not begin to install your Westinghouse product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
call Peerless customer service at 1-800-729-0307.
• Make sure that the wall will safely support the combined load of the equipment and all attached hardware and compo-
nents.
• Never exceed the Maximum Load Capacity of 90 lb (40.8 kg).
• If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an
"edge to edge" stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
WARNING
Table of Contents
Parts List .............................................................................................................................................................................. 3
Installation to Single Wood Stud Wall ................................................................................................................................... 4
Installation to Double Wood Stud Wall .................................................................................................................................. 5
Installation to Solid Concrete or Cinder Block ....................................................................................................................... 6
Installing Flat Panel Screen to Wall Plate ............................................................................................................................. 7
Adding Safety to Mount ........................................................................................................................................................ 7
For customer service call (800) 729-0307 or (708) 865-8870.