Weider WEBE09900 - Manual (Page 10)

10
ADJUSTING THE BACKREST
The Backrest (6) can be used in a decline position, a
level position, or either of two incline positions. To
adjust the Backrest to the decline position, remove
the Adjustment Pin (32) and lower the Backrest until it
rests directly on the Crossbar (3). Re-insert the
Adjustment Pin and secure it with the Pin Clip (43).
To adjust the Backrest (6) to the level position, insert
the Adjustment Pin (32) through the top set of holes,
and secure it with the Pin Clip (43).
To adjust the Backrest (6) to an incline position, insert
the Adjustment Pin (32) as shown through one of the
lower two sets of holes in the backrest adjustment
tubes. Secure the Adjustment Pin with the Pin Clip
(43).
32
Adjustment Tubes
3
43
6
WARNING:
When adjusting the
position of the seat, make sure that the
adjustment pin is inserted through both
adjustment tubes.