Zoom PD-01 - Manual (Page 5)

IN jack
The input of the unit acts as a power switch. When you connect the plug of the cable from the guitar here, the unit is turned on.
OUT jack
This is the output of the unit. Connect the plug of the cable going to the guitar amplifier or other effect device here.
AC adapter jack
When powering the unit from the AC adapter, insert the plug from the adapter into this jack. Be sure to use only an AC adapter rated for 9 V
DC, center negative, 300 mA (Zoom AD-0006). When the AC adapter is connected, the PD-01 will always be ON, regardless of whether a
cable is plugged into the IN jack.
GAIN control
Turning this control clockwise increases the drive effect. In the zero position, there is no distortion.
LEVEL control
This control adjusts the output signal level. Turning the control clockwise increases the level.
HIGH control
This control adjusts the high frequency range.
LOW control
This control adjusts the low frequency range.
Indicator
Illuminates when the PD-01 is active.
Foot switch
Switches the PD-01 effect on and off.
Battery compartment
A 9V battery (6F22) can be inserted here.
5
ZOOM Power Drive PD-01
1
2
3
4
5
6
7
8
9
10