Zebra Technologies Zebra LP 2824-Z - Manual (Page 48)

48 LP 2824-Z User Guide 980531-001 A
Troubleshooting
Print Quality Problems
Print Quality Problems
No print on the label.
• You must use the correct media for the method of printing you require. You must use
thermal transfer media.
• Is the media loaded correctly? Follow the instructions in “Loading the Media”in the
Getting Started chapter.
The printed image does not look right.
• The print head is dirty. Clean the print head.
• The print head is under temperature.
• Adjust the print darkness and/or print speed. Refer to the six-flash sequence in “Feed
Button Modes” later in this chapter, or the ^PR and ~SD commands in the ZPL II
Programming Guide.
• The media being used is incompatible with the printer. Be sure to use the recommended
media for your application, and always use Zebra-approved labels and tags.
There are long tracks of missing print (blank vertical lines) on
several labels.
• The print head is dirty. Clean the print head.
• The print head elements are damaged. Replace the print head (see “Replacing the Print
Head” in the Maintenance chapter).
The ribbon sensor settings did not print.
• The printer is set for direct thermal printing; use the ^XA^MTT^XZ command to reset the
printer for thermal transfer printing and calibrate again.