Yamaha RX-V530 - Manual (Page 16)

12
SPEAKER SETUP
SPEAKERS
MAIN
REAR
(SURROUND)
CENTER
+
–
+
–
+
–
L L R R
SET BEFORE POWER ON
MAIN : 8 ΩMIN. /SPEAKER
CENTER : 8 ΩMIN. /SPEAKER
REAR : 8 ΩMIN. /SPEAKER
MAIN : 4 ΩMIN. /SPEAKER
CENTER : 6 ΩMIN. /SPEAKER
REAR : 6 ΩMIN. /SPEAKER
IMPEDANCE SELECTOR
IMPEDANCE SELECTOR
SET BEFORE POWER ON
MAIN : 8 ΩMIN. /SPEAKER
CENTER : 8 ΩMIN. /SPEAKER
REAR : 8 ΩMIN. /SPEAKER
MAIN : 4 ΩMIN. /SPEAKER
CENTER : 6 ΩMIN. /SPEAKER
REAR : 6 ΩMIN. /SPEAKER
RX-V430
Switch
position
Left
Right
Speaker
Main
Center
Rear
Main
Center
Rear
Impedance level
The impedance of each speaker must
be 4
Ω or higher.
The impedance must be 6 Ω or
higher.
The impedance of each speaker must
be 6
Ω or higher.
The impedance of each speaker must
be 8
Ω or higher.
The impedance must be 8
Ω or
higher.
The impedance of each speaker must
be 8
Ω or higher.
(RX-V530 U.S.A. model)
■ IMPEDANCE SELECTOR switch
WARNING
Do not change setting of the IMPEDANCE SELECTOR switch when the power of this unit is on, this may damage
the unit. If this unit fails to turn on when STANDBY/ON (or SYSTEM POWER) is pressed, the IMPEDANCE
SELECTOR switch may not be fully slid to either position. If so, slide the switch all the way to either position when
this unit is in the standby mode.
Select the switch position (left or right) according to the impedance of the speakers in your system. Be sure to move this
switch only when this unit is in the standby mode.
0103V530_9-19_EN(U) 12/27/01, 10:31 PM 12