Xantrex Technology Xantrex AC to DC Converter XADC - Manual (Page 23)

Installation Instructions
975-0301-01-01 23
AC Loads
To install the AC loads:
1. Route the AC load cables through the knockouts in the back of the panel.
2. Install breaker(s) for your AC loads. See the documentation for your breaker
to determine how it installs.
3. Connect the hot lead (black) from each AC load to a breaker.
4. Connect the neutral lead (white) from each AC load to the rear AC bus on the
panel, marked “AC Neutral Terminal”.
5. Connect the ground lead (green or bare) from each AC load to the front AC
bus on the panel, marked “Equipment Grounding Terminal”.
Mounting the XADC and Panel when Connected
To mount the XADC and panel when connected:
1. Slide the complete unit into the mounting cutout.
2. Fasten the complete unit into the cutout and secure using 6 × #6 or #8 pan
head, round head or washer head screws suitable for mounting the unit onto
particleboard or wood.
3. Install the XADC faceplate and tighten the four screws (do not overtighten as
this may cause stripping of the screw threads).
4. Install the DC fuse cover.
5. Install the panel faceplate and tighten the center screw (do not overtighten as
this may cause stripping of the screw threads).
6. Close the hinged door.
Important: Make a note of which AC load has been connected to which breaker using
the provided label on the panel to the side of the breakers. Use pencil in case the circuit is
changed in the future.
Figure 17 XADC AC Connections
AC input knockouts
Main AC input and AC
loads neutral connection
to AC Neutral Terminal
Main AC input and AC loads
ground connection to
Equipment Grounding
Terminal
AC loads “hot” to
any breaker except
reserved AC line
breaker
AC line connection
to breaker 1 (30A
panel) or breaker
4+5 (50A panel)