Zanussi BMS 641 - BST 6 - Manual (Page 20)

20
The oven is designed to be connected to 230-240V (50Hz)
electricity supply.
The oven has an easily accessible terminal block which
is marked as follows:
Letter L - Live terminal
Letter N - Neutral terminal
- Earth terminal
THIS OVEN MUST BE EARTHED
Model BMS 641 is provided with a a type H05RR-F
connection cable with section 3x1,5 mm 2 .
Model BST 6 is supplied without connection cable. A
suitable one must be fitted to the appliance, according to
the following type list:
— H07 RN-F
— H05 RN-F
— H07 RR-F
— H05 VV-F
It is necessary that you install a double pole switch
between the oven and the electricity supply (mains), with
a minimum gap of 3mm between the switch contacts and
of a type suitable for the required load in compliance with
the current rules.
The switch must not break the yellow and green earth
cable at any point.
Important
After installation and connecting, the cable must be
placed so that it cannot at any point reach a temperature
of more than 60°C above the ambient temperature.
Before the oven is connected, check that the main fuse
and the domestic installation can support the load; and
that the power supply is properly earthed.
The manufacturer disclaims any
responsibility should these safety
measures not be carried out.
DIMENSIONS Height 580 mm.
OF RECESS Width 560-570 mm.
Depth 550 mm.
DIMENSIONS Height 320 mm.
OF THE Width 420 mm.
OVEN CAVITY Depth 390 mm.
Oven capacity 53.2 litres
Heating elements rating (230 V)
Oven element
1.8 kW
Top element 0.8 kW
Bottom element 1.0 kW
Convection element 2.0 kW
Grill element 1.75 kW
Double Grill element 2.55 kW
Convection Fan 30 W
Oven Light 25 W
Cooling Fan 25 W
Total Rating (230-240 V) 2.6 kW
This oven must be installed by qualified
personnel to the relevant British Standards.
Technical Data
The oven must be installed according to
the instructions supplied.
Installation
Electrical Connection