Yamaha YSP-1000 - Manual (Page 38)

AUTO SETUP
34
8
Press ENTER to start the AUTO SETUP
procedure.
The following screen appears on your TV.
ENVIRONMENT CHECK (Environmental noise
check), SUB WOOFER CHECK (Subwoofer check)
and WILL START in 10 SEC (Will start in 10 sec) are
displayed in order as the PREPARATION procedure
is in progress.
If an error occurs, an error message is displayed. See
“Error messages for AUTO SETUP” on page 35 for a
complete list of error messages and their proper
remedies. Follow the instructions and press RETURN
to perform the AUTO SETUP procedure again.
9
Check that the following screen is displayed
on your TV.
The results of the AUTO SETUP procedure are
displayed on your TV.
10
Press ENTER to confirm the results or press
RETURN to cancel the results.
The following screen is displayed temporarily for a
few seconds and then disappear from your TV.
. ENVIRONMENT CHECK
;;;[OK]
SUB WOOFER CHECK
;;;[NOT IN USE]
WILL START in 10 SEC
Move aside or behind YSP
*****-----
PREPARATION
AUTO BEAM MEASUREMENT/SET
AUTO BEAM OPTIMIZATION
. SETTING VOLUME
MEASURE DISTANCE
MEASURE FREQ CHAR
MEASURE VOLUME
ACOUSTIC OPTIMIZATION
If you selected BEAM
OPT+SOUND OPTIMZ or
SOUND OPTIMZ only in
step 5. If you selected BEAM
OPTIMZ only in step 5.
. ENVIRONMENT CHECK
;;;[OK]
WILL START in 10 SEC
Move aside or behind YSP
*****-----
PREPARATION
Skipped if you selected
SOUND OPTIMZ only in
step 5.
Skipped if you selected
BEAM OPTIMZ only in
step 5.
ENTER
BEAM MODE: 5BEAM
SUBWOOFER: NOT APPLICABLE
[ENTER]:Enter
[RETURN]:Cancel
SHOW RESULT
Example of the
SHOW RESULT screen
If you selected BEAM
OPT+SOUND OPTIMZ or
SOUND OPTIMZ only in
step 5. If you selected BEAM
OPTIMZ only in step 5.
BEAM MODE: 5BEAM
[ENTER]:Enter
[RETURN]:Cancel
SHOW RESULT
AUTO SETTING COMPLETED
ENTER