Yamaha YHT-470 - Manual (Page 12)

1
Stop the unit.
* The peak level searching function of this unit is useful for
adjusting recording level on the tape deck. (Refer to page
15.)
2
Enter the tape’s total possible recording time.
You can select any of four tape lengths by pressing the
TAPE button.
3
Otherwise, you can also enter the tape’s total possible
recording time manually.
Example: For a C-64 tape (32 minutes on each side)
4
* By pressing the REPEAT button, the unit automatically
programs tracks for side A and side B separately
considering the tape’s total time.
5
Begin recording on the tape deck and press the
PLAY button on this unit at the same time.
6
The unit will pause at the end of side A of the tape.
Turn the tape over to side B. Resume recording and, at
the same time, press the PLAY button or the PAUSE
button on this unit
.
Notes
• All tracks may not be programmed if the tape’s length is not
enough. To program all tracks, use a longer tape.
• In step 4, you can check the program data for side A and
sideB.
➀
Shows the number of programmed tracks.
➁
Shows the total time of programmed tracks.
➂ Shows the side of the tape.
➃
Shows the programmed track numbers.
TRACK PROGRAMMING FOR RECORDING TO TAPE
12
This convenient feature can be used to program tracks on a disc for recording to tape. By only memorizing the tape’s total possible
recording time, the unit will automatically program tracks or help you to program tracks so they will fit onto the tape with the least
amount of unrecorded space remaining at each end of the tape. Additionally, this function will insert sufficient time space between
programmed tracks automatically so that the tape deck can perform blank search operations correctly.
Ⅲ
Automatic tape-programming
This is for recording only the tracks which best fit onto a tape.
LOGODISK
STOP
TAPE
1 10 2 3 4 5 6 7 8 9 0 +
1 2
REPEAT
4
2 1
3
TAPE
(off)
3 4
1 2 6 5, 6