Yamaha CRX-330 - Manual (Page 14)

CONNECTING SPEAKERS
10
En
1
Remove approximately 10 mm (3/8 in) of
insulation from the end of each speaker
cable and then twist the exposed wires of the
cable together to prevent short circuits.
2
Press and hold the lever.
3
Insert one bare wire. By releasing the lever,
the lever is replaced.
■ Notes on the speaker cord
A speaker cord is actually a pair of insulated cables
running side by side. One cable is colored or shaped
differently, perhaps with a stripe, groove or ridge. Connect
the striped (grooved, etc.) cable to the “+”(red) terminals
on this unit and your speaker. Connect the plain cable to
the “–”(black) terminals on this unit and your speaker.
The low frequency range of the left channel and the right
channel are mixed to output at the SUBWOOFER OUT
jack.
Connect the SUBWOOFER OUT jack on this unit
to the INPUT jack on the subwoofer using the
subwoofer cable (commercially available).
Do not connect the power cable of this unit and the subwoofer
until all cable connections are completed.
10 mm (3/8 in)
Red: positive (+)
Black: negative (–)
Red: positive (+)
Black: negative (–)
Connecting a subwoofer
Note
SUBWOOFER
OUT
TUN
INPUT
INPUT
Subwoofer cable
(commercially
available)
Subwoofer
(commercially
available)