Yamaha DSP-A970 - Manual (Page 24)

1-4. ADJUSTMENT
MAIN/CENTER/EFFECT SPEAKER LEVEL BALANCE
ADJUSTMENT
This operation uses an internal test-tone generator for balancing
the levels of the main, center and effect speakers.
1. Depress the TEST switch on the remote control so that “TEST
DOLBY SUR.” appears in the display panel to enter test mode. A
hiss-like calibration signal should be heard from the left main
speaker, center speaker(s), right main speaker and rear effect
speakers in turn (see diagram). Adjust the MASTER VOLUME to a
normal listening level.
*
The state of test-tone output is shown by the display panel and
the monitor screen. (Especially on the monitor screen, it is shown
by an image of audio listening room.) This is convenient for
adjusting each speaker level.
2. Adjust the center and rear level by using the CENTER and REAR
LEVEL +/– keys on the remote control so that the sound coming from
the corresponding speakers seems to be at the same level as that
from the main speakers when you are at a normal listening position.
If there is insufficient volume from the effect speakers,
you may decrease the main speaker volume level by setting the
MAIN LEVEL switch on the rear panel to “–10 dB”, and adjust the
center and rear level again. Volume controls on external power
amplifiers may also be adjusted if necessary to achieve proper
balance.
3. For the front effect speaker level adjustment, depress the TEST
switch on the remote control again so that “TEST DSP” appears in
the display panel. A calibration signal should be heard from the main
speakers and the front effect speakers in turn (see diagram).
4. Adjust the front level by using the FRONT LEVEL +/– keys on the
remote control so that the speaker volume is the same as that of the
main speakers.
NOTE: If not using a center speaker, be sure to set the CENTER
MODE to the PHNTM (phantom) position.You will then hear the
center channel test tone from the left and right main speakers.
After completing this adjustment, press the TEST switch once
again.
NOTE: Once you have completed these adjustments, use only this
unit’s MASTER VOLUME control to adjust listening volume. Do not
change any other volume settings in the system.
22
Left main Center
Rear
Right main
Main Front