Yamaha DSP-A970 - Manual (Page 31)

To record a source other than the input source to be
played
This unit has a function of selecting a source to be recorded to tape
deck or VCRs independent of the selection of input source.
1. Press the REC OUT switch ( so that “REC OUT...” appears on the
display and the monitor screen).
Front panel
2. Within 5 seconds after the REC OUT switch is pressed, select the
source to be recorded with an input selector switch.
Front panel
3. Press the REC OUT switch (so that the indicator corresponding
to the selected source to be recorded stops flashing).
* The same result will be gained after 5 seconds automatically
without any operation.
4. Play the source and confirm it by selecting it with an input selector
switch and increasing the setting of the MASTER VOLUME
control.
5. Set the tape deck or VCR used for recording to the recording
mode.
* Adjust the recording level on the tape deck or VCR.
6. While recording a source, you can enjoy listening to and/or
watching another source selected with an input selector switch.
While recording, you can monitor the audio and/or video signals
to be recorded by selecting the tape deck or VCR used for recording
with an input selector switch.
29
English
Front panel
Front panel Remote control
or