Lumex Syatems 763400A - Manual (Page 7)

6
4. Plug into main electrical outlet.
NOTE
1. Make sure the pump unit is suitable for the local power
voltage.
2. The plug also serves as the disconnect device
CAUTION: The pump can only be applied to the mattress
recommended by the manufacturer. Do not use it for any
other purpose.
5 Then turn the main power switch ON. The power switch is
located on the right side panel of the pump unit.
NOTE: Ensure the CPR connectors are sealed completely.
Installation tips are listed below:
After installation, the extra wire of the power cord, if any, should be neatly arranged to avoid
any tripping accidents. The equipment should be firmly placed at position where
users/doctors can access easily.