Zebra Technologies P320i - Manual (Page 43)

B - MAGNETIC ENCODER CLEANING
There exists two different processes to clean the Magnetic Stripe Encoder.
The first process consists of a standard cleaning of the printer. This cleans
the most important parts of the printer; including the Print head, Transport
Roller and Magnetic Stripe Encoder (refer to chapter 4 "Cleaning" for more
instructions).
The second process consists of a cleaning of the Magnetic Encoder using
the Menu Button from the LCD Display.
To access the Magnetic Encoder Cleaning Menu prceed as below:
ISO STANDARD ENCODING
Card
Printer
Solutions
General information
Getting started
Operation
Cleaning
Specifications
Appendix A
Appendix B
Troubleshooting
Printing a card
Appendix C
P320i Plastic Card Printer
* Bit per inch
† Except the ‘?’ character
‡ Including Start, Stop and LCR characters. Also note that tghese 3 characters are
automatically managed by the magnetic encoder according to the ISO Standard
Norms.
NOTE: Refer to the Card Printer Programmer’s Manual for complete programming
information.
1. Leave power on.
2. Remove cards from the Card Feeder
3. Insert one Pre-Saturated Cleaning Card
(provided) through slot on the side of the Card
Cartridge.
4. Press the Menu button until the LCD screen
shows CLEANING MENU.
5. Press the Select button to select.
6. Press the Menu button again until the LCD
screen shows CLEAN MAG HEAD.
7. Run this operation by pressing the Select
button.
Track #
1
2
3
Field Separator
^
=
=
Track density
210 BPI*
75 BPI*
210 BPI*
Valid Characters
Alphanumeric
(ASCII 20~95†)
Numeric
(ASCII 48~62)
Numeric
(ASCII 48~62)
# of characters
79‡
40‡
107‡