Yamaha NS-P230 - Manual (Page 15)

English
E- 11
USING THE SUBWOOFER (YST-SW005)
Ⅵ Controls and their functions
1
Power indicator
Lights up GREEN when the POWER switch (
2 ) is
pressed in to the ON position and goes off when set to
the OFF position.
* Standby mode
If the POWER switch ( 2 ) is pressed in to the ON
position and the AUTO STANDBY switch ( 4 ) is set
to the HIGH or LOW position, this indicator lights up
RED when no signal is received by the subwoofer.
2
POWER switch
Press this switch to the ON position to turn on the
power of the subwoofer. When the power of the
subwoofer is on, the power indicator (
1 ) on the front
panel lights up GREEN. Press this switch again to set
to the OFF position to turn off the power of the
subwoofer.
3
VOLTAGE SELECTOR switch
(For China, Korean and General models)
If the preset setting of the switch is incorrect, set the
switch to the proper voltage range (220V-240V or
110V-120V) of your area.
Consult your dealer if you are unsure of the correct
setting.
WARNING
Be sure to unplug the subwoofer before setting the
VOLTAGE SELECTOR switch correctly.
4
AUTO STANDBY (HIGH/LOW/OFF) switch
This switch is originally set to the OFF position. By
setting this switch to the HIGH or LOW position, the
subwoofer’s automatic power-switching function
operates as explained on page 9. If you do not need
this function, set to the OFF position.
* Make sure to change the setting of this switch only
when the POWER switch ( 2 ) is in the OFF position.
5
INPUT2 terminals
Used to input line level signals from the amplifier.
6
INPUT1 (FROM AMPLIFIER) terminals
Used to connect the subwoofer with the speaker
terminals of the amplifier.
7
OUTPUT (TO SPEAKERS) terminals
Can be used for connecting to the main speakers.
Signals from the INPUT1 terminals (
6 ) are sent to
these terminals.
8
VOLUME control
Adjusts the volume level. Turn the control clockwise to
increase the volume, and counterclockwise to
decrease the volume.
9
HIGH CUT (HIGH/LOW) switch
Selects the high frequency cut off point.
Normally, it is set to LOW, however, you may set to
HIGH if necessary. Refer to page 12–13.
SUBWOOFER SYSTEM YST SW005 SUBWOOFER SYSTEM YST-SW005
INPUT1 FROM AMPLIFIER
OUTPUT TO SPEAKERS
INPUT2 /MONO
AUTO STANDBY
OFF LOW HIGH LOW
HIGH HIGH CUT
OFF
POWER
ON
VOLUME
0 10
220V-240V
110V-120V
VOLTAGE SELECTOR
6
7
5
9
4
8
INPUT1
FROM AMPLIFIER
OUTPUT
TO SPEAKERS
INPUT2 /MONO
AUTO
STANDBY
OFF
LOW
HIGH
LOW
HIGH
HIGH CUT
VOLUME
0 10
OFF
POWER
ON
2
110V-120V VOLTAGE
SELECTOR
220V-240V
3
1
Rear panel
Front panel
Port
NS-P230-236UB-Ea 02.5.8, 10:19 PM 11