Adjusting the subwoofer before use, Rear panel, Automatic power-switching function – Yamaha NS-P230 User Manual

Page 16

Advertising
background image

E-

12

Adjusting the subwoofer before use

Before using the subwoofer, adjust the subwoofer to obtain the optimum volume and tone balance between the subwoofer and
the main speakers by following the procedures described below.

Rear panel

INPUT1

FROM AMPLIFIER

OUTPUT

TO SPEAKERS

INPUT2

/MONO

AUTO

STANDBY

OFF

LOW

HIGH

LOW

HIGH

HIGH CUT

OFF

POWER

ON

VOLUME

0

10

INPUT1

FROM AMPLIFIER

OUTPUT

TO SPEAKERS

INPUT2

/MONO

AUTO

STANDBY

OFF

LOW

HIGH

LOW

HIGH

HIGH CUT

VOLUME

0

10

OFF

POWER

ON

3

1, 6

5

Automatic power-switching function

If the source being played is stopped and the input signal
is cut off for 7 to 8 minutes, the subwoofer automatically
switches to the standby mode. (When the subwoofer
switches to the standby mode by the automatic power-
switching function, the power indicator lights up in red.)
When you play a source again, the power of the
subwoofer turns on automatically by sensing audio signals
input to the subwoofer.
This function will operate by sensing a certain level of low
frequency input signal. Usually set the AUTO STANDBY
switch to the LOW position. However, if the power is not
switched to ON or STANDBY smoothly, set the switch to
the HIGH position. In the HIGH position, the power will
turn on even with a low level of input signal. But please be
aware that the subwoofer may not switch to the standby
mode when there is an extremely low input signal.

* The power might turn on unexpectedly by sensing noise

from other appliances. If that occurs, set the AUTO
STANDBY
switch to the OFF position and use the
POWER switch to switch the power between ON and
OFF manually.

* This function detects the low-frequency components

below 200 Hz of the input signals (i.e., the explosion in
the action movie, the sound of the bass guitar or the
bass drum, etc.).

* The minutes required to switch the subwoofer to the

standby mode might change by sensing noise from
other appliances.

This function is available only when the power of the
subwoofer is on (by pressing the POWER switch).

NS-P230-236UB-Ea

02.5.8, 10:19 PM

12

Advertising