Yamaha DPX-830 - Manual (Page 16)

12
◆ Connecting to a video player, etc.
Using the VIDEO terminal
1. Connect one end (yellow) of a commercially available video
cable to the VIDEO input terminal of this projector.
2. Connect the other end (yellow) of the video cable to the
VIDEO output terminal of the video equipment.
Using the S-VIDEO terminal
1. Connect one end of the commercially available S-video
cable to the S-VIDEO input terminal of this projector.
2. Connect the other end of the S-video cable to the S-VIDEO
output terminal of the video equipment.
When a TV tuner or VCR is connected:
When you use this projector with a TV tuner or VCR connected, no image may appear or a No Signal message may appear on the screen when
you change to a channel that is not being received. In this case, set the channels of the TV tuner or VCR again. To avoid this problem, use the
TV tuner or VCR with its channel skip function enabled. (Only channels that are being received will be displayed.)
◆ Connecting to a DVD player or HDTV decoder
This projector can be connected to a video equipment such as a DVD player or HDTV decoder. Be sure to connect component video output
terminals of the video equipment to the COMPONENT input terminals of this projector.
• Images may not be projected correctly depending on the type of
DVD player you use.
• It may take some time before an image is displayed on the screen
depending on the type of the input signal.
1
2
S-VIDEO
VIDEO
COMPONENT
Y PB/CB PR/CR
Video player, etc.
To VIDEO
output terminal
Video cable
(commercially available)
To VIDEO
input terminal
1
2
S-VIDEO
VIDEO
COMPONENT
Y PB/CB PR/CR
Video player, etc.
S-VIDEO cable
(commercially available)
To S-VIDEO
output terminal
To S-VIDEO
input terminal
VIDEO
COMPONENT
Y PB/CB PR/CR
S-VIDEO
Component cable
(commercially available)
DVD player or HDTV decoder
P
R
/C
R
P
B
/C
B Y
P
B
/C
B
P
R
/C
R Y