Preamplifier, control center, etc, Pa1235x (portion of rear panel) – Xantech PA1235X User Manual
Page 10
Page 10
Model PA1235X
© 2002 Xantech Corporation.
PA1235X can be switched ON and OFF via the switched AC outlet on the rear of a preamplifier. When the
preamplifier Power Switch is switched ON, power is applied to the DC adapter, which in turn applies 5V to 30V
DC to the PA1235X, switching it ON. Similarly, when the preamplifier is switched OFF, the DC voltage to the
PA1235X is removed, turning it OFF.
LEFT
RIGHT
2
LEFT
RIGHT
33
1V
.2V
3V
LEVEL
1V
.2V
3V
LEVEL
LEFT
RIGHT
SPEAKER
+
-- --
+
+ BRIDGED --
LEFT
RIGHT
SPEAKER
+
-- --
+
+ BRIDGED --
REMOTE MASTER
ON/OFF CONTROL
5-30 VOLTS DC
+
--
STEREO
MONO
BRIDGED
MODE
STEREO
MONO
BRIDGED
MODE
5V to 12 VDC Adapter,
such as a Xantech 781RG,
plugged into a Switched
AC Outlet on Preamplifier
Preamplifier, Control Center, etc.
This must be the positive (+)
lead (white striped lead on
Xantech Power Supply Adapters)
PA1235X
(portion of rear panel)
(+)
CAUTION:
You must use the included
220 ohm resistor.
Figure 7 – Using the PA1235X Remote Master On/Off Control Terminals