Yazoo/Kees KIKW36150 - Manual (Page 13)

13
5. Tracking knob: Located under the console
towards the front right corner. If the mower will
not travel in a straight line on a smooth sur-
face, turn the tracking knob the proper direc-
tion until it straightens out.
6. Key switch: Located on the console. The key
switch must be turned on, blades disengaged,
and drive levers locked in the thumb latches
before starting.
7. Fuel shut off valve: Located under the tank
support in the fuel line.
8. Operator presence levers: Located on the
handle. One or both levers must be pressed
against the handle for the mower to remain run-
ning, when the blades are engaged or neutral
lock bail is not locked in drive levers.
9. Brake/Bypass Lever: Located at the back of
the rear deck. Used to apply park brake or by-
pass/ IZT for free wheel (neutral) condition.
10. Throttle Control: Controls speed of engine
11. Hour Meter: Records the number of hours
the unit is operated.
12. Thumb Latches: Locks drive levers in the stop
position.
OPERATION
9 BYPASS
POSITION
DRIVE
POSITION
BRAKE
POSITION
FIGURE 11
3. Blade engagement switch: Located in the
middle of the console. To engage the blades
pull up on the switch, to disengage the blades
push down on the switch.
4. Choke: Located on the left side of the con-
sole. Use when starting cold engine do not
run choke when engine is warm. Use the
throttle to control the engine RPM.