York MPADC User Manual
Page 5
Congratulations, your Multi-Pure Water Guardian Drinking Water Appliance has been connected to your faucet and you are
now ready to start-up the unit, as follows:
Step 6
Using a paper towel or cloth, dry off all connections. Also, dry off the drinking water unit.
Step 7
Ensure that all connections are tight (CAUTION: DO NOT OVER TIGHTEN).
Step 8
Before starting the flushing and start-up process, unscrew and remove the aerator
(screen) from the filtered water spout. Rinse out the aerator to remove any debris that
may have collected on the two screens inside it. You will reconnect the aerator upon
completion of the filter flushing process.
Step 9
To purge all air from the unit, turn the housing upside down and then turn on the water.
Push the bypass lever of the diverter to start the flow of water through the unit. Allow
the water to run through the unit and filtered water spout for one minute. Then close
the bypass lever and shut off the water at the faucet.
Step 10 Turn the unit right side up and place it on your counter and check all connections to
confirm that there are no leaks.
.
Step 11 Turn on the water and push the bypass lever of the diverter valve to again start the flow
of water through the unit.
Step 12 Allow water to run through the unit to waste for approximately 25 minutes to fully flush
the filter and charge the carbon.
Step 13 Push the bypass lever inward to shutoff the flow of water through the Aqua Dome
System. Then shut off the water at your faucet and check for leaks.
Step 14 Lastly, reconnect the aerator to the filtered water spout.
Congratulations, you have completed the installation.
If you have any questions regarding the installation of your
countertop unit, call:
Please call your authorized independent dealer
V.
Start-up and Use of Your Countertop Drinking Water System
bypass
lever
Turn Unit upside
down to assure
that all air escapes
from the housing
unfiltered
water
filtered
water
aerator
5
IV. Connect the Diverter Valve to Your Faucet (continued)
Fig. 2
Fig. 1
Step 5.e
Instructions for Installing a Long Adapter
The long adapter (MC257) shown in Fig. 1 is used to connect the Hose & Diverter Valve assembly to
your faucet or sprayer hose faucet, needing more clearance for the connection.
1. Remove the aerator or screen from your faucet.
2. Take the long adapter and attach it to the opening of the spout/sprayer then connect the Hose &
Diverter Valve assembly to the adapter (Fig. 2).
3. Position the Drinking Water System on the sink to allow enough room to use the sprayer faucet.