Lubrication, Ac power fuse replacement – Zebra Technologies 600 User Manual

Page 38

Advertising
background image

Lubrication

No lubricating agents of any kind are required on this printer. Some
commercially available lubricants will damage the finish if used.

AC Power Fuse Replacement

A user-replaceable AC power fuse (see Figure 6) is located just to the left of
the power on/off switch. For use with both voltage ranges, the replacement
fuse is a 5x20 fast blow style rated at 5 Amp/250 VAC.

1. Before replacing the fuse, turn the AC power switch off and unplug the

AC power cable.

2. To replace the fuse, insert the tip of a flathead screwdriver into the slot

in the end of the fuse holder end cap.

3. Press in slightly on the end cap and turn the screwdriver slightly coun-

terclockwise. This will disengage the end cap from the fuse holder and
permit the removal of the fuse.

4. To install a new fuse, reverse the procedure.

30

S400 & S600 User’s Guide

38

Advertising
This manual is related to the following products:

400