Yamaha RX-V2090 - Manual (Page 17)

17
7
STOP VCR 1
VCR 2
V–AUX
CHAPTER/CH
— +
DISPLAY
MASTER
VOLUME
—
+
TEST
MUTING
+ +
+
+ —
—
—
—
DSP
HALL EFFECT CHURCH
FRONT LEVEL
CENTER LEVEL
REAR LEVEL
DELAY
TIME
MOVIE THEATER
JAZZ CLUB STADIUM
PRO LOGIC
SURROUND
SPORTS
ENHANCED
ROCK
THEATER 70mm TV
1 2 3 4
5 6 7 8
9 10 ON/OFF
RESET CLEAR
8
9
7
8
Select the center channel output mode according to your
speaker configuration.
(Refer to “SPEAKER CONFIGURATION” on page 7.)
CENTER
MODE
Turn up the volume using the remote control transmitter.
You will hear a test tone (like pink noise) from the left
main speaker, then the center speaker, then the right
main speaker, and then the rear speakers, for about two
seconds each. The display changes as shown below.
There are two types of tests: Dolby test and DSP test.
• DSP test:
NORMAL
WIDE
PHANTOM
TEST
• Dolby test:
Note:
When the FRONT MIX switch is set to “5ch” (5 channel
mode) the DSP test mode is not available.
* The test tone from the left rear speaker and the right rear
speaker will be heard at the same time.
To adjust the BALANCE, CENTER LEVEL and the
REAR LEVEL, go to steps 10~12.
Press the TEST button to run
the Dolby test.
9
Press the TEST button again to run the DSP test.
*
The test tone from the left main speaker and the right
main speaker, the left front and the right front speaker
will be heard at the same time.
To adjust the FRONT LEVEL, go to step 13.
• If your video monitor is on, the state of the test tone
output is also shown by an image of an audio
listening room on the screen.
In step 7, when you select the center mode, note the
following.
Seven and five speaker configuration
NORMAL: Select this mode when you use a
center speaker that is smaller than the
main speakers. In this mode, the bass
tone will be output from the front
main speakers.
WIDE: Select this mode when your center
speakers are approximately the same
size as the main speakers.
Note:
For seven speaker configurations, the FRONT MIX switch
on the rear panel should be set to the “7 ch” setting. For
five speaker configurations, the FRONT MIX switch
should be set to the “5 ch” setting.
Six and Four speaker configuration
PHANTOM: Select this mode when you do not
have a center speaker. The center
channel sound will be output from
the left and right main speakers.