Zanussi ZHC 913 - Manual (Page 11)

11
INSTALLING THE COOKER HOOD
Please ensure that when the appliance is
installed it is easily accessible to an
engineer in the event of a breakdown.
All installations must comply with the local
authorities requirements for the discharge of
exhaust air.
Incorrect installation may affect the safety of
this cooker hood.
Installation Requirements
Before installation check the wall to which the
cooker hood is to be fitted for electric cables,
water pipes or gas.
This cooker hood is designed to be fixed to
any vertical surface over a cooking area, and
can be used in the extraction (ducted to the
outside) or recirculation mode.
The installation work must be undertaken by a
qualified and competent person.
The manufacturer disclaims any responsibility for
damage due to incorrect installation of the cooker
hood or if the hood is not installed in compliance with
relevant regulations controlling this type of
installation.
Unpacking
The cooker hood is supplied with the following
components for installation:
• Canopy (C), including controls, worktop
illumination and fan unit.
• U-shaped upper chimney section (S).
• U-shaped lower chimney section (I).
• Metal recirculation plate (T).
• 120mm ducting spigot (A).
Fixing kit comprising:
• Wall fixing brackets (1,2 and 3).
• Document pack.