Zanussi ZHC 913 - Manual (Page 15)

15
Fitting the Chimney Stack
The chimney stack consists of two sections.
1. Fit the upper section (S) first. Expand the
chimney slightly to allow it to be fitted over
the brackets (1) and (2), and then secure
the chimney stack to bracket (2) using two
self tapping screws provided in the fitting
kit.
2. Fit the lower chimney section (I) by
expanding the chimney slightly to allow it
to be fitted over the brackets (1), and the
upper chimney section and bracket (3).
3. Ensure the bottom edge of the chimney
stack is fitted correctly into the recess
around the top of the canopy, and secured
using the two self tapping screws as
illustrated in the close-up above.
Note: The upper (S) and lower (I) chimney stack
sections are fixed to the middle wall
bracket (3) by the natural force of the
metal, and the over lapping of the
sections by vigorously pushing against the
centre of the chimney.