ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H - Manual (Page 401)

P-793H User’s Guide
Appendix G Command Interpreter 401
Appendix G
Command Interpreter
The following describes how to use the command interpreter. You can use telnet to access the
CLI (Command Line Interface) commands. See the included disk or zyxel.com for more
detailed information on these commands.
Note: Use of undocumented commands or misconfiguration can damage the unit and
possibly render it unusable.
Command Syntax
• The command keywords are in courier new font.
• Enter the command keywords exactly as shown, do not abbreviate.
• The required fields in a command are enclosed in angle brackets <>.
• The optional fields in a command are enclosed in square brackets [].
• The |symbol means or.
For example,
sys filter netbios config <type> <on|off>
means that you must specify the type of netbios filter and whether to turn it on or off.
Command Usage
A list of valid commands can be found by typing help or? at the command prompt. Always
type the full command. Type exit to end the session when finished.