Something not working – Zanussi ZCE 611 User Manual
Page 18
18
Something Not Working
SYMPTOM
n
The hob hotplate does not heat up.
n
The plate is not giving satisfactory results
n
The oven does not come on
n
The oven temperature light does not come on
n
The oven light does not come on
n
It takes too long to finish the dishes, or they are
cooked too fast.
n
Steam and condensation settle on the food and the
oven cavity.
n
The timer does not work
n
The oven fan is noisy
SOLUTION
u
Check that the unit is plugged in and the electrical
supply is switched on
u
Check that the RCCB has not tripped (if fitted)
u
Check the mains fuse has not blown
u
Check the correct control knob has been turned.
u
Check the plate is clean and dry
u
Check the cooking pan is the correct size for the plate.
u
Check the cooking pan has a flat bottom
u
Check the setting is correct for the type of cooking.
u
Check that both a cooking function and temperature
have been selected.
u
Check that the socket switch or the switch from the
mains supply to the cooker are ON.
u
Select a temperature with the thermostat control knob
u
Select a function with the oven function control knob.
u
Select a function with the oven function control knob
u
Check the light bulb, and replace it if necessary (see
"Replacing the Oven Light")
u
The temperature may need adjusting
u
Refer to the contents of this booklet, especially to
the chapter Using the Oven.
u
Leave dishes inside the oven no longer than 15-20
minutes after the cooking is completed.
u
Check the instructions for the timer.
u
Check that shelves and bakeware are not vibrating in
contact with the oven back panel.
If the appliance is not working correctly, please carry out the following checks, before contacting your local Zanussi
Service Force Centre.
IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation,
a charge will be made even if the appliance is under guarantee.
If after all these checks, the cooker still does not work, contact your local Zanussi Service Force Centre.