Zanussi ZVH 66 F - Manual (Page 20)

20
Installation Instructions
1
Safety instructions
Warning! This must be read!
The laws, ordinances, directives and standards
in force in the country of use are to be followed
(safety regulations, proper recycling in accord-
ance with the regulations, etc.)
Installation may only be carried out by a quali-
fied electrician.
The minimum distances to other appliances
and units are to be observed.
Anti-shock protection must be provided by the
installation, for example drawers may only be
installed with a protective floor directly under-
neath the appliance.
The cut surfaces of the worktop are to be pro-
tected against moisture using a suitable seal-
ant.
The sealant seals the appliance to the work top
with no gap.
Avoid installing the appliance next to doors and
under windows. Otherwise hot cookware may
be knocked off the rings when doors and win-
dows are opened.
z
Risk of injury from electrical cur-
rent.
• The electrical mains terminal is live.
• Make electrical mains terminal free of volt-
age.
• Follow connection schematic.
• Observe electrical safety rules.
• Ensure anti-shock protection by installing
correctly.
• The appliance must be connected to the
electrical supply by a qualified electrician.
z
Risk of injury from electrical cur-
rent.
• Loose and inappropriate plug and socket
connections can make the terminal overheat.
• Have the clamping connections correctly in-
stalled by a qualified electrician.
• Use strain relief clamp on cable.
• In the event of single-phase or two-phase
connection, the appropriate mains cable of
type H05BB-F Tmax 90°C(or higher) or an
equivalent type must be used.
• If this appliance’s mains cable is damaged, it
must be replaced by a special cable (type
H05BB-F Tmax 90°C; or higher) or an equiv-
alent type. The latter is available from the
Customer Care Department.
A device must be provided in the electrical in-
stallation which allows the appliance to be dis-
connected from the mains at all poles with a
contact opening width of at least 3 mm.
Suitable isolation devices include line protect-
ing cut-outs, fuses (screw type fuses are to be
removed from the holder), earth leakage trips
and contactors.
Sticking on the seal
• Clean the worktop around the cut-out area.
• Stick the single-sided adhesive sealing tape
provided on the underside of the hob around
the outside edge ensuring that it is not
stretched. The two ends of the tape should
join in the middle of one side. After trimming
the tape (allow it to overlap by 2-3 mm),
press the two ends together.