Zanussi GAS HOB ZGG 659 - Manual (Page 9)

9
Building in
30
20 min 60
a
b
FO 1013
Building over a cupboard or
drawer
If the hob is to be installed above a cupboard or
drawer it will be necessary to fit a heat resistant
board below the base of the hob on the underside
of the work surface.
Building over a kitchen unit with
door
Proper arrangements must be taken in designing
the furniture unit, in order to avoid any contact with
the bottom of the hob which can be heated when it
is operated. The recommended solution is shown
in diagram 1.
The panel fitted under the hob ("a") should be easily
removable to allow easy access if technical
assistance is needed. The space behind the
kitchen unit ("b") can be used for connections.
a) Removable panel
b) Room for connections
550 min.
560 min.
FO 0947
FO 0939 FO 0938
FO 0198
Building over a kitchen unit with
oven
If the hob is built into a kitchen unit with an oven
underneath, the recess must have the dimensions
shown in diagrams 2 and 3, and should also incor-
porate suitable oven crosspiece supports to ansure
an efficient cooling air circulation.
Diagrams 4 and 5 give two building-in examples.
The electric connection of the hob and the
oven should be carried out separately, for
electrical safety reasons to permit easy
extraction of the oven from the front part
of the kitchen unit.
1 2 3
4 5